If you are experiencing issues with your washing machine spinning stage, you’ve come to the right place. This guide will explain the causes of various washing machine spin cycle issues and provide solutions for you. So, without wasting any more time, let’s get right to it…
Table of Contents
Washing Machine Spinning Out Of Control — How To Fix
If your washing machine is spinning out of control, it indicates that the tube bearing is worn out. The bearing is mounted at the bottom of the tub and is responsible for ensuring that the tub stays balanced when.
To get rid of the spinning issue in your washing machine, you’ll need to replace the tub bearing. Click here to learn how to do this. Please keep in mind that the process may vary depending on the brand of your washing machine.
Washing Machine Spinning But Not Filling With Water — Solved
If your washing machine is spinning but not filling with water, it indicates that something is blocking the water supply. Most times, this is a result of clogged water inlet filters or damaged water inlet valves.
To clean clogged water inlet filters in your washing machine, all you need to do is take out the inlet hoses at the back of your washer, pull out the filters inside the ports, clean them, and put them back in.
If the issue isn’t fixed after cleaning the water inlet filters, you’ll need to replace your washing machine’s water inlet valve. Click here to learn how to do this.
Washing Machine Spinning And Leaking — Solution
If your washing machine is spinning and leaking, it indicates that the tub seal has worn out. The tub seal is mounted at the base of your washer’s tub and prevents water from leaking out during wash cycles. To learn how to replace your washing machine’s tub seal, click here.
Check out these other articles…
How To Replace Washing Machine Spin Motor — Quick Fix
Here are the steps you’ll need to take in order to replace your washing machine’s drive motor…
Step 1. Ensure that you unplug your washing machine’s power cord and turn off the water supply before attempting any repairs in order to avoid any chances of water leakage and electrocution.
Step 2. Use a tool such as a putty knife to pry the main front panel off your washing machine and set the panel aside. Afterwards disconnect the motor and mode shifter wires connected to the drive motor assembly (make sure you take note of the positioning of each wire).
Step 3. Use a pair of pliers to squeeze the motor wire retainer in order to detach the wires connected to the drive motor. Afterwards, pull the drive belt off the pulley of the drive motor.
Step 7. Remove the mounting nuts holding the drive motor assembly to the base of your washing machine (in order to completely take out the bolts, you will have to tilt the drive motor assembly forwards a little bit). pull the drive motor assembly out of your washing machine once you’ve taken the bolts off.
Step 8. Take your new drive motor assembly out of its packaging and secure it to the mounting bracket inside your washing machine by applying the mounting nuts. In order to be able to access the rear mounting nuts, you’ll have to pull the drive motor assembly forwards a bit.
Step 10. Loop the drive belt around the drive pulley and motor shaft, then insert the wire retainer into the base of the drive motor assembly.
Step 13. Connect the mode shifter and motor wires to their corresponding terminals on the new drive motor assembly, then snap your washing machine’s main front panel back in position.
Step 14. Plug your washing machine back to its power outlet and turn on the water supply, then test the washer by running a wash cycle.
Washing Machine Spinning But Not Agitating — Solved
If your washing machine spins but doesn’t agitate, this indicates that the agitator is damaged. To learn how to replace this part in your washing machine, click here.