How To Replace Belt On Frigidaire Washing Machine [Quick Guide]

Welcome to this guide on how to replace belt on Frigidaire washing machines. This article will give you easy-to-follow instructions on how to do this…

How To Replace Frigidaire Front Loader Washing Machine Drive Belt

Do the following to replace the drive belt in your Frigidaire front loader washing machine…

Step 1. Turn off your washing machine’s water supply and unplug the power cord before attempting any repairs (this will prevent any chances of water leakage and electrocution).

Step 2. Unscrew the COLD and HOT water inlet hoses from the inlet ports at the back of your washing machine (make sure to keep a rag nearby in case water leaks out of the hoses).

Step 3. Use your Philips screwdriver to take out all the screws at the back of your washing machine holding the rear panel. Pull the panel off and set it aside.

Step 4. If still intact, pull the drive belt off the motor shaft and drive pulley. Take your new washing machine drive belt out of its packaging.

Step 5. Fit the new drive belt around the motor shaft and drive pulley. Put the rear panel of your washing machine back on and apply the screws with your Philips screwdriver.

Step 6. Reconnect the water supply hoses to the inlet ports. Plug your washing machine back to its power source and turn the water supply back on. Run a wash cycle to make sure everything is working properly.

Check out these other articles…

Candy Washing Machine Error Codes [Quick Fix]

Candy Washing Machine Heating [Issues & Solutions]

Candy Washing Machine Not Spinning/Spinning [Issues & Solutions]

Candy Washing Machine Not Working [Solved]

Candy Washing Machine Tripping Electric [Quick Fix]

How To Clean Candy Washing Machine [Detailed Guide]

Frigidaire Washing Machine Not Draining [Issues Fixed]

How To Replace Frigidaire Top Loader Washing Machine Drive Belt

Do the following to replace the drive belt in your Frigidaire top loader washing machine…

See also  Whirlpool Washing Machine Cycle [4 Problems , Solutions & Detailed Guide]

Step 1. Turn off your washing machine’s water supply and unplug the power cord before attempting any repairs.

Step 2. Put some tape over the lid of your washing machine. Insert a putty knife under the main top panel of your washing machine to release the clips. Lift the top panel up and support it.

Step 3. Use your Philips screwdriver to remove the two screws at the bottom of your washing machine’s front panel. Detach the panel from your washing machine and set it aside.

Step 4. Push the idler pulley to release the tension on the drive belt. Pull the old belt off the pulley. Take your new drive belt out of its packaging.

Step 5. Fit the new drive belt around the motor and idler pulley. Snap the main front panel of your washing machine back in place and apply the two screws at the bottom to secure it.

Step 6. Lower the main top panel of your washing machine and snap it in place. Plug your washing machine back to its power source and turn on the water supply. Make sure everything is working properly by running a wash cycle.